Initialising...
← Back home / Miter Saw
Demo Mode
Absolute
0.0mm
Target
0.0mm
Relative
0.0mm
Not homed 4000 mm
Position entry
0 mm
7
8
9
4
5
6
1
2
3
.
0
⌫
GO
STOP
Nudge
0.1
0.5
1
5
10
100
200
Step: 1.0 mm
◀ LEFT
RIGHT ▶
− 50 mm/s
50 mm/s
+ 50 mm/s
Home positions
Set abs homemark here as 0
Set rel homemark relative zero
Go abs homemove to 0 mm
Go rel homemove to rel zero
⚡ Simulated demo — no hardware connected
Length
Angle
Long point length
0 mm
7
8
9
4
5
6
1
2
3
.
0
⌫
GO
STOP
Timber width
0 mm
7
8
9
4
5
6
1
2
3
.
0
⌫
Calculated fence position
—
Set angle and width,
then choose miter direction.
Nudge
0.1
0.5
1
5
10
Step: 1.0 mm
◀ LEFT
RIGHT ▶
⊕ RE-CALIBRATE
trim offset: +0.00 mm
■ STOP
⚡ Simulated demo — no hardware connected
Load project
Fence moving...
Project
0 cuts done 0 total
Current part
—
Target
—mm
Cut list
PartLengthRemainingStatus
✓ PROJECT COMPLETE — all cuts done.
Fence is at rest position.
Status: At position Position: 2.0 mm Steps/mm: 80.0000
1
2
3
4
Fence moving...
Before you start
The fence will move to 1000 mm, 500 mm, and 2000 mm in sequence. After each move, measure the actual distance from the blade to the fence stop with a tape measure or calipers and enter it below.

The system uses your three measurements to calculate the corrected steps/mm value, automatically excluding any outlier.
Fence status
At position
Current steps/mm
80.0000
Measurement 1 of 3 — 1000 mm point
The fence has moved to 1000 mm. Measure the actual distance from the blade to the fence stop and enter it below.
Commanded
1000.0 mm
You measured
—
0mm
enter actual measured distance
7
8
9
4
5
6
1
2
3
.
0
⌫
Measurement 2 of 3 — 500 mm point
The fence has moved to 500 mm. Measure the actual distance from the blade to the fence stop and enter it below.
Commanded
500.0 mm
You measured
—
0mm
enter actual measured distance
7
8
9
4
5
6
1
2
3
.
0
⌫
Measurement 3 of 3 — 2000 mm point
The fence has moved to 2000 mm. Measure the actual distance from the blade to the fence stop and enter it below.
Commanded
2000.0 mm
You measured
—
0mm
enter actual measured distance
7
8
9
4
5
6
1
2
3
.
0
⌫
Calibration results
— steps/mm
Previous: — steps/mm  · 
✓ CALIBRATED New steps/mm: —
Fence returning to rest position.